Rulebook Mock 3

A detailed diagram of a high-performance vehicle with labeled components, set in a dynamic racing environment, focusing on safety and engineering design principles.

Rulebook Mock 3 Quiz

Test your knowledge of the Rulebook Mock 3 with this engaging quiz! Designed for enthusiasts and participants alike, it covers crucial regulations and requirements that every team should know.

Challenge yourself with questions about:

Vehicle specifications
Safety regulations
Engineering design
Component requirements

15 Questions4 MinutesCreated by TestingTurtle451

Mounting plates welded to the roll hoops must be¬¬¬_________ 2 mm thick steel or_________thick aluminum, dependent of the roll hoop material.

A. Less than , 4mm

B. At most, 3mm

C. At least , 4mm

D. At least, 3mm

The supporting material file should contain

A. Exploded view drawings

B. Pictures of the vehicle

C. A and B

D. C and the parts included in BOM

The only allowed sequences of components for turbo charged or supercharged engines-

Restrictor, compressor, throttle body, engine

Restrictor, throttle body, compressor, engine

Restrictor, throttle body, compressor

Compressor, restrictor, throttle body

Lap belts with “pull-up” adjusters are recommended over “push-up” adjusters.

True

False

None of the above

The bodywork in front of the front wheels must have a radius of at least ------ extending at least -------- relative to the forward direction, along the top, sides and bottom of all affected edges

38 mm 46 degrees

39 mm 45 degrees

38 mm 45 degrees

35 mm 45 degrees

12. In Engineering Design Event, LV, structural engineering, and driver interface contains respectively…

A. 10,15,30 points

B. 30,15,10 points

C. 10,20,15 points

D. 15,10,30 points

A team can choose to use a single set of tires if they are,

Treaded or grooved

Treaded

Grooved

None of the above

First year vehicle should be used only for one year counting from

First day onsite from its first competition

Zero day of the event

First day onsite of the event participated previously

N. O. T

When LED lights are used without a diffuser, they may not be more than ____ apart.

10mm

15mm

20mm

25mm

All threaded critical fasteners must be at least ____ metric grade ___ (OEM parts 3 mm metric grade 8:8), equivalent or of that specified in the referencing rule, whichever is larger.

2mm, 8:8

3mm, 8:8

4mm, 8:8

5mm, 8:8

Measurements will be made with a free-field microphone placed free from obstructions at the exhaust outlet level, _____ m from the end of the exhaust outlet, at an angle of ____ with the outlet in the horizontal plane.

0.5m, 30 degree

0.8m, 30 degree

0.5m, 45 degree

0.8m, 60 degree

Changes in vehicle weight of more than ±5 kg compared to the official technical inspection weight results in a 30 point penalty for each kg the tolerance is exceeded by

True

False

None of the above

The “ON” position of the master switch must be in the horizontal position

True

False

None of the above

Failure of team member to follow an instruction or command directed specifically to that member or the team will result in

A. Disqualification

B. Penalty of 25 points

C. Penalty of 15 points

D. Elimination of dynamic event

Rulebook Mock 3

Rulebook Mock 3 Quiz

More Quizzes