Packet 2

Inspection of plumbing work is required:

Testing water piping shall be for a period of not less than:

A room equpped with a shower or bathtub is a :

That Part of the drainage system which extends from the end of the building drain conveys it's discharge to a public sewer, private sewer, individaul sewage-disposal system or other point of disposal is a:

Fixture coneections which may be serviced through access panel are considered:

That part of the lowest piping of a drainage systems which receives the discharge from soil, waste and other drainage pipes inside the walls of the building and conveys it to a point 2 ft. Outside the building wall is:

Which combination of fittings may be used to make an offset in a vent pipe:

Water which is safe for people to drink is referred to code as:

Code definition, a vent stack is always:

A vent which also serves as a drain is a:

A pipe which makes an angle of not more than 45 degree with the vertical is considered:

Disposal of sewage, or other liquid wastes, shall be by means of:

The liquid waste of all plumbing fixtures shall be connected to

All piping passing under or thourgh walls shall be:

Burred ends of all pipe and tubing shall be:

No plumbing system, drainage system, building sewer, private sewage, disposal system or parts thereof, shall be located in

Piping, fixtures or equipment, which are installed so that it interferes with normal operation and use of windows or doors, shall be

All trenches deeper that the footing of any building or structure and paralleling the same must be at leastt

Piping in the ground shall be laid on

Plastic pipe, ABS-DWV installed horizontally, shall be supported at not to exceed

Fixture connections between drainage pipes and water closets shall be made with

Screw or bolts for securing floor mounted fixtures shall be

Water closets or bidets shall not be closer than ____ from its center to any sidewall or partition

The overflow pipe from a fixture shall be connected to

Every water supply to urinal shall be protected by a

Drinking fountains shall not be installed in

Water closets set side by side shall be no closer than

Type "M" copper tubing wall thickness is

Vacuum breaker must be at least ___above the highest part of a urinal equipped with a flushometer valve

Vacuum breaker must be at least ___ above the surrounding ground and above the highest head for lawn sprinklers

All mealleable iron water fititings shall be

Cooper water tube type "M" may be installed within a building

After allowing for friction and other pressure losses the water pressure shall be at least

A water piping system with a pressure of 110 psi will require a

Unions shall be installed in water supply systems within 12 in. of

The type of valve allowed on a building supply to any building is a

Hard drawn copper tubing, marked with a blue stripe, is referred to as

The acceptable fitting for connecting a horizontal drain line with another horizontal drain line is at

The code requirement for testign with a 10 ft. Head of water is for

In lieu of the water test, drainage piping may be tested with

An approved material for closet screws or bolts is

A material which is not approved for cleanout plugs or caps is

A straight run of building sewer will require cleanouts at intervals of not to exceed

Which of these fixtures has the highest fixture unit rate?

The minimum length for a clothes washer standpipe is

All food equipment shall be separated from the drain by

Vent pipes protect fixture traps against

Galvanized steel pipes with galvanized steel fittings shall be kept above ground at least

Each vent pipe or stack shall extend through its flashing and shall terminate vertically above roof at least

Joints at the roof around vent pipes shall be made watertight by the use of

Horizontal vent pipes shall be level or so graded as to drip back by gravity to

Increasing vent one pipe size will

Changes in direction of vent piping shall be made by

The fitting that is required for making the yoke vent intersection with the drainage stack is a

The connection between a vent pipe and a vent stack vent shall be at least___inches above flood level rim of the hightes fixture served by the vent

All malleable iron vent or water fittings shall be

Each plumbing fixture, excepting those having integral traps, shall be separately trapped by an approved type

One trap may serve a set of not more than

The vertical distance between fixtures outlet and the trap weir hall not exceed

The trap shall be the same size or larger than

Each fixture trap shall have a water seal of not less than

Which of the following characterisitics is not a requirement of a properly installed trap

Listed metal appliance connectors for dryers may be

When supplying fuel gas to more than one building on any premises, the system shall be equipped with

Bushings in gas piping shall not be used in

Appliance connectors shall at no time have a diameter less than

One of the follwing is not required in comuting size of a gas piping system

Horizontal metallic gas piping installed underground in exterior locations shall have at least

The maximum distance between the shutoff valve and the appliance

A number 18 copper tracer wire or other approved material shall be installed with the attached to underground

No part of a gas appliance connector shall be concealed within or extended through any

Who is your favorite child?