Practice Test 1

The____may require the submission of plans, specifications, drawings, and such other information as they may deem necessary prior to the commencement of work regulated by this code.

The plumbing and drainage system of any premises under the jurisdiction of the Authority Having Jurisdiction shall be maintained in a sanitary and safe operating condition by the _____

It Shall be the duty of the ____ to make sure that the work will stand the test prescribed before giving the notification for inspection to the Authority Having Jurisdiction

A room equipped with a shower or bathtub is a _____

By code definition, a stack is always ______

A device installed in a drainage system to prevent reverse flow is a _____

Disposal of sewage, or other liquid wastes, shall be by means of ______

All trenches deeper than the footing of any building or structure and paralleling the same shall be at least _____

Threaded pipe (I.P.S) 1 1/4 inches installed horizontally, except for gas piping, shall be supported at approximately _____

All pipe, pipe fittings, traps, fixtures, materials, and devices used in plumbing systems shall be ____

Screws or bolts for securing floor-mounted fixtures shall be ____

Every water supply to a urnial shall be protected by an approved _____

Drinking fountains shall not be installed in _____

Water closets set side by side shall be no closer than ____

Ball cocks in water closet tanks shall be installed so that the critical level of the water inlet is above the full opening of the overflow pipe at least _____

A lawn sprinkler atmospheric vacuum breaker must be a minimum of ____ above the tallest sprinkler head.

PEX tubing shall not be installed within the first _____ of piping connected to a water heater.

Flexible corrugated connectors of copper or stainless steel for water heater connectors shall be limited to ____

Hard-drawn copper tubing, marked with a blue stripe, is referred to as _____

The distance between a water heater and the union on th ewater lines shall not be more than ____

The minimum size trap and trap arm for a bathtub is _____

Vertical drainage lines connecting with horizontal drainage lines shall enter through a ____

Clean outs shall be designed to be ____

All indirect waste piping that requires an airgap shall discharge into the building drainage system through ____

Vent pipes protect fixture traps against _____

Each vent pipe or stack shall extend through its flashing and shall terminate vertically above the roof at least

Copper tube shall not be used for ____

One trap may serve a set of not more than ___ single compartment sinks.

No more than ___ approved slip joint fittings(s) may be used on the outlet side of a trp

Storm water shall not be drained into sewers intended for ___

Horizontal 1 1/4 inch diameter steel gas piping shall be adequately supported at intervals not exceeding _____

Where damage is not likely to occur, underground gas piping systems shall be installed with a minimum ____of cover.

Gas meters shall not be placed ____

A gas equipment shutoff valve shall be permitted to be located _____

Underground non-metallic gas piping shall be installed with a tracer wire of minimum ___