QUIZZELLA 2

In back view brake light must be mounted at
Vehicle's Centerline
Near vertical
Wheel's Centerline
Combining the “standard” IA peak load of ___ kN with the failure load for the mounting of the non-crushable object(s), calculated from fastener shear and/or link buckling
85
100
95
90
Which of the following incorrect about : If the side impact structure is part of a composite structure, the following is required:
The vertical side impact structure must have an EI equivalent to two baseline steel tubes and half the horizontal floor must have an EI equivalent to one baseline steel tube.
The vertical side impact structure must have an absorbed energy equivalent to two horizantal line steel tubes.
The perimeter shear strength must be at least 7.5 kN
The LVMS must be mounted in the middle of completely _____ placed in a high contrast background.
red circular area of>50mm diameter
blue circular area of>=50mm diameter
blue circular area of>50mm diameter
red circular area of>=50mm diameter
The minimum allowed ___ of the shutdown button on both side of the vehicle is___mm.
radius, 40
diameter, 40
radius, 50
diameter, 50
Changes issued by FS2020 Rules are indicated by
Text in green
Text in blue
Both of these
Which of these is incorrect:
All aerodynamic devices forward of the front face of the driver head restraint support, excluding any padding, set to its most forward position, must be lower than 500 mm from the ground.
All aerodynamic devices in front of the front axle and extending further outboard than the most inboard point of the front tire/wheel must be lower than 250 mm from the ground.
All aerodynamic devices rearward of a vertical plane through the rearmost portion of the front face of the driver head restraint support, excluding any padding, set to its most rearward position must be lower than 1.2 mm from the ground.
In side view any portion of the brake system that is mounted ok the sprung part of the vehicle must not project below
The lowest member of the chassis
The lowest surface of the chassis
None of the above
In post event inspection the penalty faced by group A for autocross is
2min
2s
0.3s
30 s
The marks allotted for novelty in BPP
5
10
15
20
After technical inspection, the modifications not permitted to the vehicle are:
Adjustment of belts, chains and clutches
Adjustment of the brake bias
Adjustment of the suspension where part substitution, other than springs, sway bars and shims, is required
The maximum sound level test speed for a given engine will be the engine speed that corresponds to an average piston speed of
16.25m/s
15.25 m/s
10.75m/s
17.75m/s
The LVMS must be marked with " LV" and a symbol showing a __ spark in a __ edge __ blue triangle.
red, blue, white
blue, red, white
blue, white, red
red, white, blue
A statement of _ shutdown button must be installed in the vehicle.
2
3
1
4
Each shutdown button must be a push pull Or push-rotate mechanical emergency switch pushing the button ___ the shutdown circuit
close
Open
None of the above
{"name":"QUIZZELLA 2", "url":"https://www.quiz-maker.com/Q4WSZX03","txt":"In back view brake light must be mounted at, Combining the “standard” IA peak load of ___ kN with the failure load for the mounting of the non-crushable object(s), calculated from fastener shear and\/or link buckling, Which of the following incorrect about : If the side impact structure is part of a composite structure, the following is required:","img":"https://www.quiz-maker.com/3012/images/ogquiz.png"}
Powered by
Quiz Maker
Powered by: Quiz Maker