Digkas quiz

No parts of the vehicle are allowed 70mm front and rear, measured horizontaly,of the outside plane of the wheel assembly.

True

False

What is true about the APPS?

The transfer functions must differ 10 percent.

If an implausibility occurs and persists more than 100ms the APPS must open the SDC.

Four sensors may be used as APPS.

All EVs and CVs must use APPS.

Which of the following indicators must be in the cockpit?

TS off, IMD, AMS, ASB.

IMD, AMS, TS off.

IMD, AMS, ASB.

TS off, Enable, AMS, IMD.

According to FS rules what is considered true?

All parts of the motors, including its mountings must be rated for 120 degrees.

In wheel motors are not allowed.

The wheels may be spun in reverse if there is a safety critical situation.

A non-perforated 2 mm aluminium alloy 6005A-T6 may be used for the housing of the electric motors.

What is not true about the Shutdown Circuit?

All parts of the SDC must be on the high-side connection of the AIR coils and the pre-charge circuitry.

The voltage in the TS must be discharged below 60 VDC and 50 VACRMS in less than 5 s in all circumstances.

All circuits that are part of the SDC must be designed in a way, that when the accumulator is disconnected from the car, they open the SDC.

All interlocks must not act through any power stage.

None of the above.

Components of suspension system:

May be covered but must be visible at technical inspection.

Cannot be covered.

Cannot be covered without being visible.

Alter material used other than steel for the front bulkhead must have a perimeter shear strength equivalent to aluminium plate.

True

False

A team member is about to give his master thesis and get his degree on March 14, but the formula student competition starts at July 21:

He should wait until next semester.

He is fine.

He should contact the officials to grant him permission.

He is a non-valid team member.

An ASR can be inspection responsible person for:

Electrical inspection.

Autonomous inspection.

Accumulator inspection.

All of the above.

Your team was awarded the fourth best score of the cost and manufacturing event with 85 points and the best team had a score of 91 points. The officials decided not to make the finals. What is your team’s final score?

88,7

B. 85

Digkas quiz

More Quizzes