Rule Book

A futuristic engineering lab with various design blueprints and safety equipment, showcasing students and professionals engaged in a hands-on project.

Engineering Design Quiz

Test your knowledge with our comprehensive quiz designed for engineering students and professionals. This quiz covers essential topics related to design concepts, safety standards, and engineering practices.

Challenge your understanding of crucial engineering rules
Improve your problem-solving skills in a competitive setting
Prepare for engineering competitions and certifications

15 Questions4 MinutesCreated by TestingTurtle47

Reclined driving position is

Position with a seat back angled at less than 30° from the horizantal as measured along the line joining the two 200 mm circles of the 95th percentile male template

Position with a seat back angled at more than 30° from the horizantal as measured along the line joining the two 200 mm circles of the 95th percentile male template

Position with a seat back angled at more than 30° from the vertical as measured along the line joining the two 200 cm circles of the 95th percentile male template

Position with a seat back angled at more than 30° from the vertical as measured along the line joining the two 200 mm circles of the 95th percentile male template

The shoulder harness mounting points must be

A) between 18 cm and 23 cm apart, measured center to center

B) between 180 cm and 230 cm apart, measured corner to corner.

C) between 180 mm and 230 mm apart, measured center to center.

D) Both a and c

The tilt test will be conducted with the smallest driver fully strapped in normal driving position.

True

False

In the event of unsportsmanlike conduct, _________ penalty points will be deducted from the team’s EDP score.

25 points

15 points

Max 25 points

None of the above

The laminate encapsulating the front hoop must overlap by at least ________mm on each side.

31. Front bulkhead support system must consist of-

A. Minimum 4 tubes on each side

B. Maximum 3 tubes on each side

C. Minimum 1 tube on each side

None of the above

The drag course is a straight line with a length of approximately _______ from starting line to finish line

200m

1000m

2000m

2500m

The Least points in Engineering Design Concept Event are from

Driver Interface

Presentation

LV – Electrics

Structural Engineering

Two drivers with the fastest lap times within each grid will be selected to participate in the Semi Finals.

True

False

A team can have a maximum of _______ and a minimum of __________ members registered for the competition.

2,20

20,5

20,2

15,3

Each team must register a minimum of _____ drivers and a maximum of ______drivers

4, 6

4, 8

2, 4

2, 6

The pressure inside compressed gas systems may exceed _____.

1000000 N/m^2

1000000 KN/m^2

1000000 N/mm^2

100000 N/m^2

A minimum of ____ half threads must project from any lock nut.

One

Two

Three

None of the above

The exhaust outlet(s) must not ____ behind the centreline of the ____ and shall be ____ above the ground-

Extend more than 450mm / Front axle / more than 600mm

Extend less than 400mm / Rear axle / no more than 600mm

Extend more than 400mm / Front axle / more than 650mm

Extend more than 450mm / Rear axle / no more than 600mm

The action of opening the shutdown circuit must occur if the implausibility is persistent for-

More than 100 ms

Less than 500 ms

More than 500 ms

Less than 100 ms

Unlock and Upgrade

Remove all limits from your Quizzes

Rule Book

Engineering Design Quiz

More Quizzes