Rulebook mock

A detailed illustration of a competitive team environment, showcasing team members preparing for a race or event, with documentation and technical inspection elements in view.

Team Member Eligibility Quiz

Test your knowledge on team member eligibility and documentation requirements before the competition. This quiz will help you understand the important rules and guidelines that ensure all participants are fully prepared.

Key areas covered:

Graduation timelines
Document classifications
Technical inspection protocols

15 Questions4 MinutesCreated by CompetitiveCoder202

Team members who have graduated within the ____________ month period prior to the competition remain eligible to participate

Teams that submit documents which miss the initial deadlines of group A by more than __________will be de-registered from the competition.

124 hours

168 hours

186 hours

166 hours

___________ on a particular day must attend the team briefing for that day.

Drivers

Captains

Both A and B

Only captain

All suspension mounting points must not be invisible at technical inspection, either by direct view or by removing any covers.

True

False

Steel tubing has to be made from unalloyed carbon steel with a maximum content of ________ manganese, ________carbon, and __________of any other element.

0.6% , 0.3%,0.2%

1.7%,0.3%, 0.6%

0.3%,0.6%,0.3%

0.2%,0.3%,0.7%

Which of the following is false about IA?

At least 100 mm high and 200 mm wide for a minimum distance of 200 mm forward of the front bulkhead

Not part of the non-structural bodywork.

Able to penetrate the front bulkhead in the event of an impact.

Designed with a closed front section.

The distance between the center of the circle and the rearmost actuation face of the pedals must be minimum __________

91.5cm

0.815m

0.915m

95.1cm

Position with a seat back angled at more than _________ from the vertical as measured along the line joining the two _______mm circles of the 95th percentile male template

60 deg ,200mm

30 de, 0.220m

60 deg , 200cm

30 deg , 200mm

A minimum cross sectional area of ___________ of steel to be sheared or failed in tension at any point of the tab

60 m2

60 mm2

70 mm2

70 m2

The shoulder harness must be between _______ below the horizontal and ________ above the horizontal

20°,10°

10°, 20°

10°, 25°

15°, 20°

Repeated actuation of the switch must close the shutdown circuit, and it must be designed so that the driver cannot reset it.

True

False

All forward facing edges of aerodynamic devices that could contact a pedestrian must have a minimum diameter of ______ for all horizontal edges and ________ for vertical edges.

5mm , 3mm

10mm , 6mm

50cm , 30cm

10cm , 60cm

The LVMS must be mounted in the middle of a completely red circular area of ≥25 mm radius placed on a high contrast background

True

False

Rulebook mock

Team Member Eligibility Quiz

More Quizzes