TLE

Name:

_____ is the term commonly known as technology and science

______ are by-product of trees

_______ woods that came from trees, either softwood or hardwood

________ prepared lumber for variety of uses.

_________ it comes from evergreen or needle bearing tress, these are also called conifers

__________ it comes broad leafed trees that shed their leaves at the end of the season.

________ is lumber good of appearance

________ it is suitable for rough carpentry

__________ the part of wood that is closed to the bark

_________ inner part of the wood that is made of accumulated dead cells

________ a thin layer that divides the inner part of the wood and bark

______ is the lengthwise seperation of the wood

______ is a branch or limb of a tree that has been exposed when the log is cut

______ internal cavity that contains resinous material

______ discoloration of the wood surface

______ seperation between the annual growth rings

S2S

S4S

_______ the process of drying the wood in preperation for use

_______ filling the wood in open air

_______ the use of oven to dry wood

Use of chemical compound before seasoning

_% for softwood

_% for drywood

_______ is a tool made of steel. It is used to produce very smooth surface

_______ these are used to eliminate deep cuts and holes

_______ Is a wood finishing material deprive from different colors

_______ a finishing material came from gum substance of insects

_______ produces a highly glossy finish to a project

_______ is the process of putting work together

_______ the end of one piece is fastened to the surface or edge of other piece

_______ the corners are cut usually at 45 degrees and joined forming right angle

_______ used on the corners of drawers and chairs

_______ is one of the strongest joint for quality chairs,tables, and benches

_______ is a groove that runs on the board and receives the end or edge of the second board

_______ is a wood joint commonly used for making frames to hold glass in constructing drawers

_______ steel tape is assembled in a fix casing and retracts automatically by spring

_______ is used when u know the marks will dissapear

_______ is used for testing the squareness of two squares

_______ It is used in laying out and marking the thickness and width of stock

_______ the tool can be set to lay out any angle

_______ is used to lay out positions for drilling and boring holes

_______ are used for dividing space equally

_______ is used for holding a work of piece to allow work to be performed in it

_______ is used for gluing up large surfaces

_______ it is used for holding auger bits

_______ is used for cutting large and round timber

_______ it is designed in sawing along the grain

_______ it is designed in cutting across the grain. The shape of the teeth is similar to knife blades

_______ it has stiff blades for more accurate work both on bench and the vise

_______ Is used to cut metal

_______ used in cutting irregular shapes

_______ used in cutting circle shape in wood

_______ it is used in reducing the thichness or width of a piece of wood

_______ It is used to plane convex and concave edges

_______ it is used in cutting edges and carving wood

_______ it is designed for boring holes in wood

_______ it is used for holding auger bits and other tools with rectangular shape shanks

_______ a set of twist drills and used for drilling both metal and wood

_______ it is used in boring holes with small diameter

_______ it is used in driving and pulling nails

_______ it is made of wood and it is used in driving chisels with wooden handles

_______ it has a round knob at the back of the hammer. it is used in metal work

It is the most common roof, because it is simple, economical and may be used in anytype of structure

This roof has four sides or slopes running a upward toward the center of the building to create a ridge

This roof used where hasty or temporary construction is needed

this roof is framed of two intersection hip or gable roof