Formula Ashwariders rulebook test

Which of the following statements is true?

Enclosed chassis structures and structures between the chassis and the ground must have two venting holes of not more than 2.5 cm diameter in the lowest part of the structure to prevent accumulation of liquids.

Team members who have graduated within the ten month period prior to the competition remain eligible to participate.

In the side view, no part of the front hoop can be inclined more than 20 degrees from vertical

None of these

Throttle cables must be located not more than ________ from any exhaust system component and out of the exhaust system

5 cm

0.05 m

50mm

All of these

Which of the following is not true?

The cost explanation file is a document containing additional explanations which allow the judges to understand the DBOM part of the BOM

The action of opening the shutdown circuit must occur if the implausibility is persistent for more than 500 ms.

The brake pedal must be fabricated from steel or titanium or machined from steel ,aluminium or titanium.

Both a and c

Vehicles must only be driven under power when running in a dynamic event , on the practice track and during brake test

True

False

With an “__________ driving position”, in the side view the lap belt must be at an angle of between 45° and ______° to the horizontal.

UPRIGHT ,80

RECLINED ,80

UPRIGHT,65

RECLINED,65

The minimum static ground clearance of any portion of the vehicle other than the tyres, including a driver must be _____

3cm

2.5 cm

0.3 m

None of these

Catch cans must be rigidly mounted to the chassis and located towards the firewall below the drivers shoulder level

True

False

Which of the following is not prohibited?

A single brake acting on a limited slip diffrential

Brake by wire systems

Unarmoured plastic brake lines

None of these

Which of the following is not true

Team members must be at least 16 years of age.

The smaller track of the vehicle (front or rear ) must be equal to or more than 75% of the larger track

Aluminium wheel nuts must be used, but they may be hard anodized and in pristine condition

All of these

Multiple panels may be used to form the firewall but must overlap at least 5mm and be sealed at the joints

True

False

Any vent for other systems containing liquid lubricant or coolant must have a catch can with a minimum volume of 10% of the fluid being contained or 100 ml, whichever is smaller

True

False

Any portion of the roll bar, roll bar bracing or chassis which might be contacted by the driver's helmet must be covered with a minimum thickness of _________ of padding which meets SFI spec 45.1 or FIA 8857-2001.

10 mm

0.12 cm

0.012 m

None

The scoring of the cost and manufacturing will vary from ______ to _______ points

100,80

80, 100

100, 86

None

__________ points are awarded to every team that finishes endurance without DNF or DQ

Formula Ashwariders rulebook test

More Quizzes