Formula bharat

A modern racing car on a track with engineers and mechanics reviewing notes and blueprints, vibrant and dynamic atmosphere

Formula Bharat Quiz Challenge

Test your knowledge about the rules and regulations of Formula Bharat! This quiz covers essential topics related to automotive engineering, safety standards, and competition regulations.

Multiple-choice questions
Key concepts from the Formula Bharat manual
Perfect for aspiring engineers and racing enthusiasts

15 Questions4 MinutesCreated by DrivingData247

Choose the incorrect statement

Tires on the same axle must have the same manufacturer, size and compound

Tire warmers are not allowed

Special agents that increase traction may be added to the tires or track surface

Tires that are specifically constructed by manufacturers to be run in wet conditions cannot be used as dry tires

All aerodynamic devices forward of a vertical plane through the rearmost portion of the front face of the driver head restraint support, excluding any padding, set to its most rearward position, must be

Above 500mm from the ground

Below 500mm from the ground

Lower than 500mm from the ground

No higher than 250mm from the ground

All aerodynamic devices lower than__ mm from the ground and further rearward than the front axle, must not be wider than a vertical plane touching the most outboard point of the front and rear wheel/tire

250mm

300mm

500mm

1.2m

In side view, the lap belt must be capable of pivoting freely by using a shouldered bolt attachment

An eye bolt attachment

Either of the two

None of the two

Which is correct

The lap belts and anti-submarine belts must not be routed over the sides of the seat

The lap belt must not pass around the pelvic area

The lap belts should not come through the seat at the bottom of the sides of the seat

All are incorrect

When a HANS device is used by the driver, FIA certified __ wide shoulder harnesses are allowed

75mm

100mm

50mm

150mm

The IA assembly during IA testing, must __ the vehicle at a rate not exceeding _ average and ____peak.

Accelerate ,40g 60g

Decelerate, 20g, 60g

Decelerate, 20g ,40g

Decelerate, 10g,60g

If a team wants to to apply again after deregistration, the team should submit and correct the reason for deregistration within a timespan of

1 day

3 days

5 days

7 days

Select the Incorrect option w.r.t suspension

Usable wheel travel is of at least 50 mm

Minimum jounce and rebound of 25 mm with driver seated

Minimum jounce of 25 mm with driver seated

After passing the noise test the function of the master switch, the cockpit-mounted shutdown button and the inertia switch will be tested.

True

False

Irrelevant

For finger guards, mesh or perforated material may be used but must prevent the passage of _ through the guard.

10mm dia

12mm dia

10mm radius

12mm radius

Any __ battery located in the driver compartment must be enclosed in a non conductive, water proof and acid resistance container.

Dry cell

Wet cell

Secondary cell

Primary cell

LV batteries must have a

Rigid and sturdy casing

Flexible and sturdy casing

Flexible and petty casing

Rigid and petty casing

Battery pack based in lithium chemistry other than

lithium iron phosphate

Lithium aluminium silicate

Lithium diHydrogen phosphate

Lithium iodide

Formula bharat

Formula Bharat Quiz Challenge

More Quizzes