Q1

The IA assembly, when mounted on the front of a vehicle with a total mass of _______ and impacting a solid, non-yielding impact barrier with a velocity of impact of _________.

Vehicles with aerodynamic devices and/or sensors in front of the front bulkhead must not exceed the peak deceleration of T3.19.1 for the combination of their IA assembly and the non-crushable object(s).

Any harness attachment to a monocoque must be using one 10 mm metric grade 8.8 bolt or two 8 mm metric grade 8.8 bolts (or bolts of an equivalent norm) and steel backing plates with a minimum thickness of _____________ .

Pass-throughs for wiring, cables, etc. are permitted if grommets are used to seal the pass-through

The centerline of the lap belt at the seat bottom should be between 0 mm to _____ forward of the seat back to seat bottom junction

If a vehicle stalls before passing the finish line and cannot restart without external assistance, the vehicle is DQ for that run.

For efficiency scoring, the consumed fuel volume does not exceed_____________ .

To detect hard braking, a brake system pressure sensor must be used. The threshold must be chosen such that there are no locked wheels and the brake pressure is less than or equal to ______.

LV batteries must be securely attached to the chassis and located within the surface protection envelope

The maximum allowable internal diameter of the intake runner system between the restrictor and throttle body is 60 mm diameter, or the equivalent area of ________ if non-circular.

All fuel vent lines must exit outside the bodywork.

Software calibration changes are prohibited after TI .

In side view any portion of the brake system that is mounted on the sprung part of the vehicle must project below the lower surface of the chassis.

Penalty for incorrect EDP link within ED supporting docs is___________.

DI stands for ______