Rule book quiz 26/05

Create an engaging illustration of vehicles in a testing environment, featuring engineers inspecting cars and students reviewing vehicle engineering concepts in a classroom setting.

Vehicle Engineering Rule Book Quiz

Test your knowledge and understanding of essential vehicle engineering concepts and regulations with our comprehensive quiz. This quiz covers key aspects of vehicle design, safety protocols, and performance metrics.

Multiple choice questions
Challenge your knowledge
Gain insights into vehicle engineering standards

15 Questions4 MinutesCreated by NavigatingKnowledge42

VED

Vehicle Engineering delivery

Vehicle Enigne design

Vehicle Engineering data

Vehicle Engineering Design

Penalty points for CGMR is ______ & it will be deducted from ______

10 , ED

5, Overall

5 , BPP

15 , ED

The vehicle must be equipped with fully operational front and rear suspension systems including shock absorbers and a usable wheel travel of at least ________and a minimum jounce of ______with driver seated.

50 mm ,30 mm

75 mm ,25 mm

50 mm ,20 mm

50 mm ,25 mm

Enclosed chassis structures and structures between the chassis and the ground must have two venting holes of __________diameter in the lowest part of the structure to prevent accumulation of liquids.

At least 30 mm

At most 25 mm

At least 25 mm

More than 25 mm

The load applicator used to test any panel or tube must be metallic and have a radius of _______

50 mm.

100 mm.

30 mm.

70 mm.

In side view any portion of the brake system that is mounted on the sprung part of the vehicle must not project below the lower surface of the chassis.

True

False

Any vent for other systems containing liquid lubricant or coolant must have a catch-can with a minimum volume of _______of the fluid being contained or _____, whichever is greater.

10% ,300 ml

10% ,100 ml

20% ,100 ml

50% ,900 ml

The following methods are accepted as positive locking mechanisms:

Cotter pins.

Locking plates.

Tab washers

All of the above

One shutdown button serves as a cockpit-mounted shutdown button must have a minimum diameter of

24 mm

25 mm

30 mm

40 mm

In Vehicle number, The stroke width and spacing between number should be _______

At least 20 mm

At least 30 mm

At most 20 mm

At most 30 mm

The following items must be presented for pre-inspection

All helmets

All driver‟s equipment and other safety gear

One sets of four tires mounted on rims for dry and wet driving conditions

Both A & B

Losing a part of the vehicle on the track will result in DQ for that particular run

True

False

Danger, the driver must slow down, something has happened beyond the flag station, no overtaking unless directed by the track marshals.

Yellow flag

Red flag

Black flag

Green flag

In, skid pad layout The centers of these circles are _________ apart.

18.25 m

19.25 m

21.25 m

20 m

Rule book quiz 26/05

Vehicle Engineering Rule Book Quiz

More Quizzes