Chapter 5

Walls, Floors, Ceilings, shelves or other parts of a building constructed of wood, wood lath, and plaster, composition or paper defines:

Listed factory-made pipe and fittings for conveing products of combustions to the outside atmosphere defines:

An appliance designed primarly to supply hot water and is equipped with automatic controls liming water temperature to a maximum of two hundred ten degrees is a:

In a building of unusually tight construction, combustion air shall:

Combustion air openings shall:

Water heaters that depend on the combustion of fuel shall not be located in a

Electric water heaters may be installed in a garage provided:

Water heaters more than______above the floor level shall be made accessible by stairway or ladder permanently attached to the building

Venting Systems shall be designed and constructed:

On a roof of 4/12, the vent shall terminate:

The T & P line shall extend for the valve to the outside of the building:

The T & P line shall terminate ____ above grade.

Each pressure relief valve shall be set at a pressure not more than:

A___ shall be installed on the cold water supply at or near the water heater

Single wall metal vent connectors, where permitted, shall be provided with ______ clearance from combustibles

A single wall vent connector shall not originate in a/an:

Vent connectors of natural draft appliances___connected to the mechanical systems operating under positive pressure

A water heater may use plastic pipe for its venting systems if it is listed as a:

Discharge from a relief valve into a water hater pan is:

Two gas-fired water heaters with a 3 in. Vent outlet on each water heater are c ent system. What is the minimum size of the common vent

Water heaters wich depend on combustion air may be installed in a

A final water heater inspection shall be made only after:

Water heaters supported from the ground must be on

Both openings for combustion air shall