Power Plant Steam (Final Exam)

Based on Kongsberg ERS Exercise on the operation of a Steam Boiler: When Steam Drum temperature is 105 degrees centigrade what will be the next step you should do?

MD86; The Turbo generator should start to roll slowly. Let the turbine rotate for how many minutes at 15 percent speed?

The speed can be remotely adjusted by lower/raise signals from the electric switch board, or the manual set-point adjustment at the throttle valve

Based on Kongsberg ERS Exercise on the operation of a Steam Boiler, Set the four controllers to the manual, the master at 7, the fuel flow and oxygen controllers at?

On ERS exercise on the Operation of a Steam Boiler: Decrease the airflow controller to 10 and decrease the fuel controller to Allowing the burner to fire continuously.

In monitoring the deviation of normal operating conditions, what is the ideal boiler water level?

There is a ____________fitted for cleaning purposes which uses air as the operating medium from the service air system

It is important that the turbine is started slowly. This is to reduce during start up.

The turbine is modelled realistically with torque dependent on steam flow, inlet steam pressure/temperature and condenser vacuum. The is controlled by a speed governor

To stop the turbo alternator because of malfunction, Slowly close the emergency stop valve to 20% open for how many minutes in order to remove instability within the steam supply system?

The Turbo generator is modelled with engine driven the Turbo alternator via a fresh water cooled cooler as well as an electric pump drawing from a LO tank and discharging to ☑

What is the mimic diagram when you are going to open V00367 (DO to boiler), V00327 (HO to Boiler) and V00328 (HO Service Tank shutoff valve)

Based on Kongsberg ERS Exercise on the operation of a Steam Boiler: The Aux Boiler have started Boiler Air Fan, set the four controller to manual. The master controller must be set to?

The turbo-generator is fed with ______ steam from the exhaust boiler

What is the mimic diagram when steam drum temp 1050 C (drum pressure over= 0.23bar) shut Boiler Vent Valve (V05103) & Super heated steam line vent valve (V5008)?

What is the ideal Exhaust boiler water circulating flow?

To stop the turbo alternator, After the turbo-alternator has cooled down and leave for 10 minutes, what will be your next step to be done?

What is the mimic diagram when you are told to open seawater to steam condenser?

What is the ideal feedwater tank level of the exhaust boiler on ERS? Time

What is the mimic diagram when you are going to change the air flow should be set at 100 and the purge cycle initiated. When the purge cycle is complete (the purge indication releases) change the air flow controller value to 10?

If the turbo-generator is started with much water present in the steam line, turbine rotor, and is indicated by a turbine trip. Will occur. This can severely damage

What is the mimic diagram when you are instructed to engage the turning gear for about 1 minute. On disconnection reset the turbine trip?

What is the mimic diagram when you want to ensure that the turbo alternator is not supplying electrical load. If so open the circuit breaker using the procedure within the electrical section?

What is the alarm activated during your exercise on the operation of an EGB steam turbine/turbo generator?

What is the ideal Steam temp outlet for Exhaust Boiler superheater?

The exhaust fired boiler produces steam of 9 bar and superheated to?

Water ingress into the lubricating oil sump is modelled. Hence the turbo-generator lube oil tank should be drained off regularly and new oil added. Very low/high lube oil temperature or very high water content will reduce the lubrication ability of the oil and cause rotor instability and possible turbine trip What trip is this?

MD86, Open the turbo generator emergency stop valve to how many percent?

What is the ideal feedwater tank temperature of the exhaust boiler on ERS?

On ERS exercise on the Operation of a Steam Boiler: Check the boiler water level is within normal working limits, what should you do if you observed during watchkeeping that the level of water is not in the normal level?

It is the lower bank of tubes section where the saturated steam from the oil fired boiler passes in via the upper header of the bank and counter to the gas flow to out of the lower header to the turbo-alternator, cargo pumps and ballast pump.

Based on Kongsberg ERS Exercise: before the gradual opening of the main shut off valve, what procedure is first action in order to remove moisture present on the steam line?

What is the mimic diagram when you are going to reset the boiler Trip - Burner management "ready" light should illuminate, so now switch it on?

It is the top bank of tubes section where the feedwater passes through the tubes counter to the gas flow in an Exhaust

MD86, Continue to open the valve very slowly, up to 40% over for how many minutes?

What is the allowable pressure before you can start a turbo generator?

What is the mimic diagram if you are going to raise the water level to + 75 and stop the pump. Monitor the water level and repeat this operation as necessary when the level drops below - 75?

What is the ideal Exhaust temperature after boiler (inlet stack)?

What is the mimic diagram when the main steam line pressure rises to 1.0, shut steam line drain (V05378)?

MD86, Check the level and water content of the turbo generator. What will you do when you see this Z.50?

MD86, What is the speed of the turbo generator when the emergency stop valve should be opened to 100% and steam line drain will be closed closed?

What is the mimic diagram when you are going check the boiler water level is within normal working limits?

When the level in the steam drum drops below -10, open Boiler Main feed valve, put Feed controller in MAN and start the Main feed pump Adjust the MAN output to ____?

On ERS exercise on the Operation of a Steam Boiler. The airflow should be set at 100 and the purge cycle initiated. When the purge cycle is complete the airflow controller value to?

What is the mimic diagram when you are instructed to start Main Condensate pump and No 1mvacuum pump?

Before start of cold turbo-generator the main steam line and turbine casing must be____ for water.

When the turbo-generator is shut down, a gradual collection of ___ in the steam line/turbine casing is modelled.

MD86. Engage the tuming gear for about ____ On disconnection reset the turbine trip.