Engineering Safety Standards Quiz

The minimum width of the scatter shield should be at _________ times the width of the chain or belt

Hairpin Turns must have ___________outside diameter

Or endurance event, (Slaloms)Cones in a straight line with ________ to ______ spacing

Any catch can must vent through a hose with a minimum internal diameter of ___________ down to the bottom level of the chassis and must exit outside the bodywork

The scoring of the BPP finalists will vary from _______________ points and is scored immediately after the BPP finals by all judges.

Enclosed chassis structures and structures between the chassis and the ground must have two venting holes of at least _________ radius in the lowest part of the structure to prevent accumulation of liquids.

Any tubing with a wall thickness ________________ or a minimum area moment of inertia less than 6695 mm4 is considered non-structural and will be ignored when assessing compliance to any rule regarding the vehicle structure.

The perimeter shear strength of the monocoque laminate in the front bulkhead support structure must be at _________

All fasteners attaching scatter shields and guards must be _________ metric grade 8.8 or stronger

The device must trigger due to an omni-directional peak acceleration of ___g for a half sine test pulse of ______ ms length and _________ g for a half sine test pulse of _______ ms length.

If the vehicle is unable to pass the ___________ after three attempts, the vehicle must be repaired and then brought back for retesting.

The pitch deck should contain no more than 12 slides

Any portion of the air intake system that is less than ________ above the ground must be shielded from side or rear impact collisions by structure built

The region that is longitudinally forward of the main hoop and aft of the front hoop and vertical from the bottom surface of the chassis to ______ above the lowest inside chassis point between the front and main hoop must have an EI equal to the three baseline steel tubes that it replaces

All moving suspension and steering components and other sharp edges inside the cockpit between the front hoop and a vertical plane 100 mm rearward of the pedals, must be shielded with solid material.