FSG#107

1.In acceleration event the time of the fastest vehicle including penalties is 3.95 seconds. Your first driver did both of his runs without any penalty(1st run=4.31 seconds, 2nd run =4.22 seconds). Your second driver on his first run received an OC and on his second run received an DOO, when his time was 4.05 seconds(without the DOO). So whats your team’s score?

a)54.27 points

b)57.77 points

c)61.27 points

d)0 points

4.The output voltage waveform of a common-emitter amplifier is … with its input voltage wave

a)out of phase by 180 degree

b)lagging by 90 degree

c)leading by 90 degree

d)in phase

5.What is the purpose of helium during welding?

a)Protect from oxygen

b)Protect from hydrogen

c)Protect from water vapor

d)Protect from carbon dioxide

6.Which of the following statements are not true ?

a)A vehicle with front track 1412 mm front track , 44.09 in rear track , 5.031 ft wheelbase is not rules compliant.

b)A red rectangular brake light with shining surface of 2.9205 sq.in is a suitable brake light.

c)The fuel system should have a provision for emptying the fuel tank if required.

d)Unarmored plastic brake lines are prohibited

7.Considering that the chain’s width is 1,8cm, which of the following scatter shields widths is rule compliant?

a)0,2 ft

b)2,1 in

c)6,3 mm

d)36 mm

8.A plastic film moves over two drums. During a 4-s interval the speedof the tape is increased uniformly from v0 = 2 ft/s to v1 = 4 ft/s.Knowing that the tape does not slip on the drums, determine the angular acceleration of drum B.Answer rad/sec^2 with one decimal

9.Which of the following are not true?

a)The firewall must extend sufficiently far upwards and/or rearwards such that any point less than 3,94 inches above the bottom of the helmet of the tallest driver must not be in direct line of sight any part of the fuel system, the cooling system or the engine oil system.

b)Pass through for seat belts may be used if grommets are used to seal the pass through.

c)All moving suspension and steering components and other sharp edges inside the cockpit between the Front Hoop and a vertical plane 100 mm rearward of the pedals, must be covered by a shield made of a solid metal material.

d)The Diagonal Side Impact Member must not triangulate the bays created by the Upper and Lower Side Impact Members.

12.A team submitted the document of FTO before the initial deadline expires. After that officials request a correction of this document. The team uploaded a corrected version after six hundred thousand seconds following the request. What’s the total penalty?

a)5

b)10

c)0

d)35