Quiz 10

When drawing a free body diagram of a dancer pushing off in a jump, which of the following forces are NOT to be considered
The speed of the dancer across the floor
The dancer's weight
The Friction of the floor on the dancer's shoe
Both a scalar quantity and a vector quantity require magnitude. In addition, a vector requires to full define it.
Area
Length
Direction
Normal Force
None of the above
Force due to friction ______ as the mass of the object increases.
Increases
Decreases
Remains constant
Disappears
Too fully define a vector quantity, you must specify a _____
Length in magnitude
Length in area
Area in direction
Direction and magnitude
None of these
If a body has an initial velocity of -20 m/s and it experiences an acceleration of -9.81 m/s2 for 2 seconds, which of the following is true?
The magnitude of the velocity will increase
The direction of motion will be reversed
The displacement will be positive
The body will have a final velocity of 20 m/s
All of these are true
2 javelin throwers Bob and Joe release their javs at the same velocity. Joe releases hi a a height of 2.3 m, while Bob releases it at a height of 2m. For them both to maximize their respective horizontal displacements, which of the following is true about their release angles?
They should both be exactly 45 degrees
Joe's release angle should be greater than Bob's
Bob's should be greater than Joe's
Joe throws his at Bob
Which of the following explains why a positive acceleration does not always indicate an increase in the magnitude of velocity?
Gravity is usually negative
Acceleration of a body can reflect a change in the velocity of direction
Acceleration is calculated from inst. velocity, and that value is typically positive
Horizontal velocity is independent of gravity
Positive acceleration always does indicate an increase in the magnitude of velocity
In mechanics, acceleration may be used to describe
A change in motion of a body at rest or in motion
An increase in speed of a body at rest
A change in direction of a moving body
All of these
None of these
Which variable below does not influence the flight time of a projectile?
Height of release
Initial vertical velocity
Angle of release
Initial horizontal velocity
If a body of constant mass is travelling with a constant velocity,
There must be no force acting on the body
There must be no unbalanced force acting on the body
There must beforce acting on the body
There must be an unbalanaced force acting on the body
Need more information
Which quantity uses a chnage in linear momentum?
Impulse
Impact
Force
Work
None of these
If a net horizontal force is applied to a body that is at rest, the body will
Stay at rest
Stay at rest until the net force is removed
Accelerate
Accelerate when the net force is removed
Need more information
The form of energy associated with the stiffness and deformability of an object is called
Kinetic energy
Strain energy
Molecular energy
Gravitational potential energy
None of these
The force to be considered in calculating the work you perform when climbing up a set of stairs is your
Mass
Weight
Height
Percent body fat
None of these
Kinetic energy is the energy due to
Due to deformation
Due to motion
Due to position
Due to weight
None of these
Mechanical work is performed in all of these types of muscle activity except
Isometric
Eccentric
Concentric
All of these
None of these
The difference b/w positive and negative work stems from the direction of motion of the body the force acts on and the
Megnitude of the force acting on the body
Point of application of the force acting on the body
Line of action of the force acting on the body
Direction of the force acting on the body
There is no difference between positive and negative work
Gravitational potential energy is the energy
Due to deformation
Due to motion, relative to the earth
Due to position, relative to the earth
Due to weight
Kids use to run around the room
Stability may be increased by
Raising the center of mass
Decreasing the number of contact points in the base of support
Widening the base of support perpendicular to an oncoming force
None of these
Leaning away from an oncoming force
 
 
{"name":"Quiz 10", "url":"https://www.quiz-maker.com/QPREVIEW","txt":"When drawing a free body diagram of a dancer pushing off in a jump, which of the following forces are NOT to be considered, Both a scalar quantity and a vector quantity require magnitude. In addition, a vector requires to full define it., Force due to friction ______ as the mass of the object increases.","img":"https://www.quiz-maker.com/3012/images/ogquiz.png"}
Powered by: Quiz Maker