Automotive Safety Compliance Quiz
Automotive Safety Compliance Quiz
Test your knowledge on essential automotive safety standards and regulations! This quiz covers critical aspects of vehicle design, safety equipment, and compliance requirements. See how well you understand the guidelines that keep vehicles and their drivers safe.
- Multiple choice questions
- Focuses on safety and engineering standards
- Validate your expertise in the automotive field
Which of the following is incorrect
The filler neck opening must be directly accessible without removing any parts of the vehicle
The filler neck must have a fuel filler cap that can withstand severe vibrations or high pressures such as could occur during a vehicle rollover event.
A clear filler neck tube may be used as a sight tube.
High pressure fuel Lines must be rigidly connected every _ by mechanical fasteners to structural engine components.
50 mm
75 mm
100 mm
Which of these is incorrect for the support tube for a member of primary structure if it is a bent tube or made from multiple tubes:
Be of the same dimension as the supported tube(s)
Terminate at the node of chassis
Be angled more than 30° from the plane of supported tube(s)
Which of the following doesn't meet the requirements for a driver's helmet:
Snell K2009
SFI 31.5/2005
FIA 8860-2004
Which of the following is incorrect for VSV
assembled sequences are allowed CORRECT
Driving in a separated or protected area
Must be presented in ready to race condition including body works
must run under its own power
if drivers who have missed attending the drivers briefing for the day will not be allowed to drive the car for
Whole competition
Only for the day and except autocross
Only for that particular day for all events
depends on dynamic event instructor
Low pressure fuel system are those functioning at a pressure
Below 10 bar
below 10 atm
below 15 bar
signal only influencing indicators - indicating a failure
Of its own function
the connected system
Both fo the above
Which of the following are excluded from the LVS voltage limit
Which of teh following are excluded from the LVS voltage limit
High voltage system for injectors
Voltage internal to OEM charging system designed for <60V DC output
All of the above
The maximum sound level test speed for a given engine will be the engine speed that corresponds to an average piston speed of 15.25 m/s. The calculated speed will be rounded to the nearest 500 rpm. The maximum permitted sound level up to this calculated speed is
103 db fast weighing
109 db fast weighing
110 db fast weighing
BOTS ___ consist of a ______connection of switches.
May, parallel
Must , series
May , series
Must , parallel
All moving suspension and steering components and other sharp edges inside the cockpit between the front hoop and a vertical plane __________of the pedals, must be shielded with solid material
25 mm forward
50 mm rearward
100 mm rearward
Any catch can must vent through a hose with internal diameter of ____down to the bottom level of the chassis and must exit outside the bodywork.
Maximum 4mm
Minimum 5mm
Minimum 3mm
The shoulder harness straps must be threaded through the _______ bar adjusters in accordance with the manufacturer’s instructions.
6
2
3
1
The distance between the centre of the 200mm circle of the percy and the rearmost actuation face of the pedals must be ___________.
Maximum 490mm
Maximum 280mm
Minimum 915mm
Minimum 280mm
{"name":"Automotive Safety Compliance Quiz", "url":"https://www.quiz-maker.com/QPREVIEW","txt":"Test your knowledge on essential automotive safety standards and regulations! This quiz covers critical aspects of vehicle design, safety equipment, and compliance requirements. See how well you understand the guidelines that keep vehicles and their drivers safe.Multiple choice questionsFocuses on safety and engineering standardsValidate your expertise in the automotive field","img":"https:/images/course6.png"}