Rulebook Quiz

Find: (A/B)+C

A= Points for finances in BPP

B= Points for missing item (Assembly)

C= The EDP is a maximum ____ minute recorded video presentation

The following item must not be presented at mechanical inspection:

Jacks and push bar

Copies of any impact attenuator data requirement

The tallest driver of the team

Chassis material sample

The maximum sound level test speed for a given engine will be the engine speed that corresponds to an average piston speed of _____ km/h. The calculated speed will be rounded to the nearest _____ rps. The maximum permitted sound level up to this calculated speed is _____ dB(C), fast weighting.

59.4, 8.33, 110

115.25, 500, 110

59.4, 7.36, 110

61.7, 8.33, 110

Find: B*(A+C)

The maximum allowable internal diameter of the intake runner system between the restrictor and throttle body is __(A)__ cm diameter, or the equivalent area of __(B)__ cm2 if non-circular.

Gasoline fueled vehicles - __(C)__ mm

735.02

2261.6

22616

7350

Which of the following is TRUE.

Open fuel containers are permitted at the competition

Engine running is allowed in the engine test area and in the dynamic area, when the vehicle is jacked up using a quick jack

Only team captains must attend the team captains’ briefing for that day.

The VSV will be reviewed in order of submission. A review may take up to three weeks.

Team "APEX" scored maximum points in BPP, lost 20 points in Cost and Manufacturing Prelims, and only attempted Round-1 of Engg Design Event and scored maximum points. Team further scored maximum points in Autocross and Endurance and didn't attempt other dynamic events. What is the total score of the team?

695

595

610

710

Find: {(A.B+D)/(C-D)*20}....................(take approx value)

A= Penalty points for exceeding pitch or presentation time limit (10)

B= Late Correction Submission Points penalty per 24h for TMI (0)

C= Late Submission Points penalty per 24h for PS (10)

D= Penalty points for incorrect file naming (2)

137

131

Any system on the vehicle that uses a compressed gas as an actuating medium, except for gas springs, must comply with the following requirements:

Gas cylinders/tanks and their pressure regulators, must be shielded from the driver.

Gas cylinders/tanks must be insulated from any heat sources.

Gas cylinders/tanks must be securely mounted to the chassis, engine or transmission.

The pressure inside compressed gas systems must exceed 10 bar.

Which of the following is true for securing fasteners?

A minimum of two full threads must project from any lock nut.

Adjustable tie-rod ends must not be constrained with a jam nut to prevent loosening.

All critical fasteners must be secured from intentional loosening by the use of positive locking mechanisms

All of the above

Rulebook Quiz

More Quizzes