Exit Exam

A summit curve is formed at the intersection of a 3% up gradient and 5% down gradient. To provide a stopping distance of 128m, the length of summit curve needed will be:

F civil engineers inform the client via document about a certain change involving site implementation then civil engineers can already implement the change with or without the approval of the client.

T is an uncertain event or condition that, if it occurs, has a positive or negative effect on one or more project objectives such as scope, schedule, cost, and quality.

In order to be recycled concrete cannot contain

A curving roadway has a design speed of 80 km/hr. At one horizontal curve, the superelevation has been set at 6% and the angle of side fraction is found to be 6❰. Determine the impact factor 0.19

A soil has a specific gravity of 2.68 and a void ratio of 0.73 if the degree of saturation is 92%. Compute the dry density of the soil in g/cc

N Project Management, it refers the sequence of project network activities which add up to the longest overall duration. This determines the shortest time possible to complete the project

The steel tensile strain limit for a tension-controlled failure is

The branch of engineering that deals with improvement of traffic performance, traffic studies and traffic network is called ______.

A floor joist 50mmx 200mm has a span of 5m. If it carries a total floor load of 5kPa. Determine the spacing of joist in mm to develop a bending stress of 8MPa.

These members are generally vertical and resist axial compressive loads

A surveying student walked along a given line that was known to be 200.0 ft long to determine her average unit pace. She paced the line four times, recording 78,76.5,77 and 76 paces, respectively, in her field book. If the surveyor then counted on average of 123.5 paces while pacing off a line of unknown distance, what is the distance?

Locational clearance requirements in acquiring building permit are the following except:

An open channel to be made of concrete is to be designed to carry 5m3/s at a slope of 0.00655. Find the most efficient cross section for (a) semicircular section (solve for the diameter in m)

In general, it is the densification of soil by removal of air, which requires mechanical energy

Civil engineers can act independently as long as it is written in the contract.

The resistance factor for tension in structural steel in gross section yielding is

Which of the following does not belong to the group?

It is a measure of the size of the particle cement

They are flat horizontal panels that support the floor.

It is the minimum distance required to stop a vehicle before it reaches a stationary object.

Concrete compressive strain is expected to be at _________ when the concrete is on theverge of crushing as per NSCP.

What is the effect of staggered holes in steel tension members?

If super elevation is not provided on a horizontal curve of a highway, then on which portion of the road are pot holes likely to develop?

Calculate the steel ratio that will produce a tension-controlled failure if compressive strength f’c = 28 MPa and steel yield strength fy

Calculate the steel ratio that will produce a tension-controlled failure if compressive strength f’c = 28 MPa and steel yield strength fy

Reservoir A has an elevation of 300 mm circular pipe is connected to it with diameter of 300 mm and length of 200 m, while reservoir B is at an elevation 200 mm with circular pipe connected to it diameter 250 mm and length of 250 m and Reservoir C elevation with a circular pipe attached to it, diameter is 600 mm and length of 450mm. All pipes meet at junction. Determine the flow rate in Pipe A in m3/s. Use f=0.02

Metropolitan Manila has a road network following which type of road pattern?

It is A government policy covering technical requirements in constructing or renovating building and structures in the Philippines to secure the life, health, property and welfare of the Filipinos

The maximum super elevation to be provided on the road curve is 1 in 15. If the rate of change of super elevation is 1 in 120 and the road width is 10 m, then the minimum length of the transition curve on either end will be: