FSNetherlands Registration Quiz Test 3

The wheels and brakes guys want a pressure at their brake lines enough to make the world stop.

No problem, Pinincolomi will install performance brake lines made from porous carbon fiber because weight reduction bro. Forocoches told him he would also gain feedback at the pedal

Brake lines are not considered as high pressure hydraulic lines

The shields must be steel or aluminium and will have a minimum thickness of 1mm

The shields must be steel or aluminium and will have a minimum thickness of 3mm

Which of the following restrictions regarding regenerative braking is true?

It is only allowed to regenerate 90% of the brake energy.

The brake pedal must have enough travel to allow the BSE to show a linear, positive slope transfer function for the regenerative braking.

The action of regenerating energy, if used, can not be deactivated by the driver.

It is only allowed to regenerate energy if the car is moving faster than 5 km/h.

If the PrechargeResistor we are using is a 1 kΩ, 1000 W power Resistor, and the voltage rises from 0 V to 90% of the total voltage in 7.3 s, what is the equivalent Capacity of the Inverters we use? Assume our total voltage is 7/8 times the maximum allowed by the rules.

3170 mF

3170 uF

69.28 mF

69.28 uF

A fabrication process of a stuffing piece requires the following processes with their corresponding times for each operation:

It can be seen that the bending process delay the rest of the operations, accumulating stock before it. If it’s wanted to stuff 20 pieces, in which moment we’ll have more accumulation of stock inside the process?

At the beginning of the process

When the piece 20 starts his fabrication

When the piece 10 starts his fabrication

It can’t be answered with security

A serie of blocks are stacked on top of each other so that only ⅔ of the surface of the upper block rests on the lower one as the figure shows. What will be the block that will drop the heap? m=5 Kg, L= 3cm

The forth

The fifth

The sixth

The seventh

When an electrical vehicle should return at the charging area the temperature measuring device?

Before 2 hours after his endurance is finished

Throughout the last competition day

A inspector should come for it at the team’s box after finished the endurance

Leaving parc fermé after finished the endurance

Your team has a support of a box attached to the Front Hoop Bracing, which of the following answers is correct?

Your team has to use a DIN 933, DIN 931, DIN 912 or DIN 7984 with a minimum metric grade 8.8 or equivalent bolt.

Your team hasto use a DIN 933, DIN 931, DIN 912 or DIN 7984 with a minimum metric grade 6.8 or equivalent bolt.

Your team can use an attachment without using fasteners.

Your team can use wire ties.

1- Which of the items must be presented compulsorily during electrical inspection?

Samples of all self-designed PCBs of the car.

The Charger of the TS accumulator.

Set of tires on rims for wet conditions.

One ESO.

FSNetherlands Registration Quiz Test 3

More Quizzes