WFH Ops Quiz 3

An aerial view of a drone flying over a scenic landscape, with symbols of navigation, flight paths, and recovery systems incorporated into the design.

WFH Ops Quiz 3

Test your knowledge and skills with our WFH Ops Quiz 3! This quiz is designed to assess your understanding of critical operational procedures related to aircraft, navigation, and recovery systems.

Whether you're preparing for certification or simply want to challenge yourself, this quiz covers a range of topics:

Directional Antennas
Flight Maneuvering
Stall Conditions
Communication Parameters

13 Questions3 MinutesCreated by FlyingEagle321

What occurs when the CAT command is sent?

The air vehicle calculates an airspeed required for safe climb out

The autopilot commands maximum throttle

Elevons are slightly deflected upwards

All of the above

What are the limits of the roll / pitch rate respectively?

±69 deg per sec / ± 30 deg per sec

±30 deg per sec / ± 69 deg per sec

±30 deg per sec / ± 44.4 deg per sec

±30 deg per sec / ±30 deg per sec

Which wind conditions are within limits for continued flight?

Steady at 25 knots, gust to 37 knots

Steady at 45 knots

Steady at 30 knots, gust to 35 knots

Steady at 30 knots, gust to 42 knots

Which is true with regard to aircraft stalls?

The risk of stalls during flight decreases with slower airspeed

Stalls can occur due to flight at minimum airspeed

Stalls will not occur due to mechanical turbulance

When there is a stall, the autopilot will not take action to recover the aircraft

Which of the following is true of the aircraft in flight?

To level off at an altitude, the aircraft maintains airspeed and decreases engine RPM

To level off at an altitude, the aircraft decreases airspeed and decreases engine RPM

When the aircraft is told to increase speed, it may change in altitude and will not return to the original altitude unless commanded to do so

The degree of altitude deviation does not depend on the rate of change in airspeed

What happens when the "Direct to waypoint" command is used?

The kill perimeter is created around the 2 waypoints that define the course

The aircraft has a chance of exiting the kill perimeter

I-MUSE calculates a direct course from the aircraft's current position to the waypoint

The aircraft will attempt a perpendicular turn on course to the waypoint

Which is not a reason for a missed capture? (In maritime-based context)

Aircraft GPS failure

CTL switch was moved to the not clear to capture position

The true airspeed differed from the commanded airspeed by 10%

Aircraft was above the miss high at the value specified in the recovery editor

What does the mission parameter file determine?

Engine kill radius

Air vehicle configuration

Pilot's console timer

Telemetry packet structure

Which is a parameter in the SkyHook Recovery section of the Recovery Set Up Sheet?

AutoScale Plot

Touchdown offset from GPS

Sidestep in go-around

Home

Which is true of the Communication parameter file?

It identifies the communication timeout

It identifies the UART reset period

It is only modified by Insitu

All of the above

Which is the correct set of equipment needed to program the Scaneagle from the maintenance laptop?

Umblical cable, 24V Power supply, Edgeport/1 to serial USB adaptor cable

Umblical cable, 18V Power supply, Edgeport/1 to Edgeport/1 cable

Umblical cable, 24V Power supply, USB to USB adaptor cable

20V Power supply, Edgeport/1 to serial USB adaptor cable

Unlock and Upgrade

Remove all limits from your Quizzes

WFH Ops Quiz 3

WFH Ops Quiz 3

More Quizzes