Automotive Safety Standards Quiz
Automotive Safety Standards Quiz
Test your knowledge of automotive safety standards with this comprehensive quiz. Designed for engineers, students, and enthusiasts alike, this quiz covers critical topics related to vehicle design, safety regulations, and engineering best practices.
- Assess your understanding of safety protocols
- Challenge yourself with multiple-choice questions
- Gain insights into automotive standards and regulations
For sleeved joints the sleeve must have a minimum length of _______ either side of the joint and be a close-fit around the base tubes
.36m
.036m
0.038m
If the attachment point of the upper member is _____________ above the upper side impact member, node-to-node triangulated bracing is required to transfer load to the main hoop.
>0.001m
<100 mm
>15cm
<0.015m
If (IA) is welded to the front bulkhead, it must extend ____________ to the centerline of the front bulkhead tubing in all directions
Equal
At least
At most
None of the above
Impact Attenuator Document size must be
2mb
10mb
1mb
7mb
The energy absorbed in IA TEST event is ________________
=7350 J
>=7350 J
<7000 J
<=7000J
Seated in a normal driving position, the driver must have a ________ field of vision of ___
Minimum, 100 deg
Maximum, 100 deg
Minimum, 200 deg
Maximum, 200 deg
Each hydraulic circuit must have its own fluid reserve, either by the use of separate reservoirs or by the use of a __________ reservoir
Dammed
Tandem
Simple
Both a and b
Which Prevailing torque lock nuts are accepted as positive locking mechanisms
ISO 7042
ISO 7040
ISO 7050
ISO 7045
The vehicle number background must not be one of the following
Oval
Square
Rectangle
Circular
Full form of AFFF
Aqueous friction foaming foam
Additive film forming form
Aqueous film forming foam
Additive film foaming form
Lines must be rigidly connected every ________ by mechanical fasteners to structural engine components.
50mm
75mm
100mm
110mm
After technical inspection, which of the following modifications is restricted to the vehicle?
Software calibration changes
Replacement of defective brake pads
Both a and b
None of the above
If analog sensors are used, they must have different, ___________________.
Intersecting receiver functions
Non-intersecting transfer functions
Intersecting transfer functions
Non-intersecting receiver functions
When power is removed, the electronic throttle must immediately close at least to idle position ______________
±5%
±10%
±15%
±20%
Which of the following is false statement regarding steering wheel
Near circular
Continuous perimeter
Include concave section
250mm rearward of front hoop
{"name":"Automotive Safety Standards Quiz", "url":"https://www.quiz-maker.com/QPREVIEW","txt":"Test your knowledge of automotive safety standards with this comprehensive quiz. Designed for engineers, students, and enthusiasts alike, this quiz covers critical topics related to vehicle design, safety regulations, and engineering best practices.Assess your understanding of safety protocolsChallenge yourself with multiple-choice questionsGain insights into automotive standards and regulations","img":"https:/images/course1.png"}
More Quizzes
Automotive Safety and Design Regulations Quiz
15818
FB 2020
311619
QUIZZELLA 2
1589
Engineering Inspection Challenge
840
Tank Construction Testing Quiz
10553
Formula bharat rule book practice quiz
1588
QUIZELLA 1
1589
Mock Test
15810
Vehicle Dynamics Knowledge Quiz
15811
Formula bharat
1586
Automotive Safety Regulations Quiz
15817
Mock Test
15814