FSN2021

1) What is true about front hoop bracing?
If the front hoop is inclined to the front, additional braces are required
In side view, bended front hoop bracings are allowed as long as proper triangulation is used
The front hoop bracings may be attached within 100mm from the top-most surface of the front hoop, if the front hoop is declined to the rear and additional braces are used
Front hoop bracings must extend beyond the driver's feet
2) During Autocross, you are forced to stop on track due to a flat tire. Are you allowed to replace the tire and queue again for the next run in Autocross?
Yes, this is allowed
No, once you have failed to complete a run in autocross you are not allowed to do another run
No, the car must first be aproved by officials again in mechanical inspection
No, the car is no longer ready-to-race
3) What is not true regarding the Engineering Design Event?
Judges can request the team to provide evidence of information in the EDR
Judges may ask a presenter for general engineering knowledge
Judges will only consider vehciles that will pass scrutineering in their judgement
Judges will not include the information presented in the Design Spec Sheet in their judgement
4) During the endurance event, it has suddenly started raining. Which flag can you expect?
Blue Flag
Red and Yellow Striped Flag
Black Flag
Black Flag with Orange Dot
5) What is not accepted as a critical fastener?
Grade 10.9 steel nuts with thread locking fluid (i.e. Loctite)
M8 Nylon lock nut
35CrMo4 Jet Nuts
Steel Tab Washers
The Wet Skid Pad World Record was set at FSN2019 by TU Delft. They managed to set a time of 4.901 for the left circle and a time of 5.031 for the right circle. Assume the run was completed perfectly along the center line of the circles. What was their average speed during this record run?
9.65m/s
11.55m/s
13.44m/s
15.34m/s
7) Although the FSN Endurance track is improved yearly, one particular corner has been featured since the first edition in 2017. The 'Schmidt S' named after its creator, is a very tight chicane at minimum track width. What is the track width in this corner?
3m
4m
5m
9m
8) What is the minimum ground clearance, with the driver seated?
25mm
30mm
40mm
50mm
9) What is the penalty for a fluid leak (without advantages for the team) in Autocross?
No penalty, but a voluntary re-run
2 s penalty
5 s penalty
DQ
10) What is true about Cost Report Documents?
Part dimensions can be stated in any unit of measurement
The LV system is classified as a system within the BOM
The CRD can be presented digitally to the judges at the event
The Brake System is broken down into sub-systems
11) What is true about firewalls?
Wires cannot run through a firewall
Hydraulic fluid lines must be seperated from the drivers compartment by a firewall
A firewall must be made from a single panel
A firewaal cannot be used for heat insulation of the driver compartment
12) Besides displacement, what terms are used to define your engine in the design spec sheet?
Diameter and Length
Diameter and Stroke
Bore and Length
Bore and Stroke
13) What factor is not used to determin the RPM level for the noise test?
Bore
Piston Speed
Engine RPM
Stroke
14) During a run in your practice area, your vehicle stalls. Your driver is unable to start the vehicle. Can team members help to push-start your vehicle?
Yes, but only in the practice area
Yes, but only if the team members use the push bar
No, vehicles may only be started by using the on-board starter
No, team members are not allowed to enter the practice area
15) Team NSF is experiencing issues with their engine. What is never allowed?
Cranking the engine before the vehicle has passed mechanical inspection
Cranking the engine in the pits
Leaving the driven whels on while running the vehicle
Usaing a quick jack to lift the driven wheels when running the engine
16) What is true about electrical systems for CV class vehicles?
Inertia switches may be reset via an electrical connection
The maximum permitted voltage in the low voltage system is 60V DC or 30 V AC RMS
CV Class vehicles can have high voltage systems
LV Master switches must be installed on either side of the vehicle
{"name":"FSN2021", "url":"https://www.quiz-maker.com/QPREVIEW","txt":"1) What is true about front hoop bracing?, 2) During Autocross, you are forced to stop on track due to a flat tire. Are you allowed to replace the tire and queue again for the next run in Autocross?, 3) What is not true regarding the Engineering Design Event?","img":"https://www.quiz-maker.com/3012/images/ogquiz.png"}
Powered by: Quiz Maker