Design RuleBook

A technical illustration of a vehicle design with highlighted sections on safety standards and structural integrity, incorporating aspects like roll hoops and harness systems, in a modern engineering style.

Design RuleBook Quiz

Test your knowledge on the essential design rules and standards in engineering! This quiz covers various aspects of vehicle design, safety regulations, and structural integrity.

Challenge yourself with questions such as:

True or False statements regarding safety standards
Multiple-choice questions on material specifications
Requirements for vehicle components and structures

15 Questions4 MinutesCreated by EngineeringGuru507

Which of these is TRUE?

The load applicator must have a radius of 60 mm

The laminates encapsulating the front hoop must overlap by minimum 25 mm on each side

If the panel core thickness is 5 mm then the test panel must measure 250 mm x 275 mm

During IA test 50 mm clearance forward of the AIP is a must

Which of these is FALSE?

Any harness attachment to a monocoque must use two 10 mm metric grade 8.8 bolt or two 8 mm metric grade 8.8 bolts

All of these

The front hoop bracing structure must be attached no lower than 50 mm below the top-most surface of the front hoop

All aerodynamic devices lower than 500 mm from the ground and further rearward than the front axle, must not be wider than a vertical plane touching the most outboard point of the front and rear tire

If multiple panels are used for floor closeout, the gaps between panels must

Be less than 0.3 mm

Be less than 4 mm

Exceed 3 mm

Be at least 0.4 cm

Which of the following is TRUE?

Reflective foil or tape cannot be used for heat insulation

Floor closeout must extend from front bulkhead to the main hoop

None of these

No part of the primary structure may lie below 20 mm of the endpoints of the roll hoops

Pass-throughs for wiring, cables, etc. Are permitted if grommets are used to seal the pass- through in firewall

False

True

All vehicle controls must be operated from inside the cockpit without any part of the driver being outside the vertical planes coincident to the outermost surface of the side impact structure

True

False

Which of the following is TRUE for shoulder straps?

Y type strap configuration is allowed

H type strap configuration is allowed

None of these

All of these

Which of the following is FALSE?

All aerodynamic devices must not extend further rearward than 250 mm from the rearmost part of the rear tires

Minimum area moment of inertia for driver's restraint harness attachment is 8409 mm^4

If AIP is welded to the front bulkhead, it must extend at least to the centerline of the front bulkhead tubing in all directions

Head restraint must have minimum height and width of 150 mm

All threaded critical fasteners

Must be 4 mm metric grade 8.8 except OEM parts

Can be ISO 4017, ISO 4014 and DIN7379

Can be DIN7984 and DIN980

All of these

Which of the following is TRUE?

The fire extinguishers must have a minimum firefighting capacity of 0.9 kg

Stroke width and spacing between vehicle number must be at least 30 mm

The front hoop shouldn't be aluminium welded structure

None of these

Design RuleBook

Design RuleBook Quiz

More Quizzes