FAR QUIZ
FAR Circuit Compliance Quiz
Welcome to the FAR Circuit Compliance Quiz, designed to test your knowledge and understanding of the technical specifications and requirements essential for circuit compliance in motorsport scenarios. Are you ready to challenge yourself?
Key Features:
- Multiple choice questions covering various technical aspects
- Engaging format to enhance learning
- Immediate feedback on your answers
The shutdown circuit must remain open until power cycling the LVMS or the BSPD may reset itself if the opening condition is no longer present for
More than 10 s.
More than 5 s.
Less than 10 s.
Less than 5 s.
Which of the following are SCSs?
BSPD
BOTS
APPS
TPS
What is true about Main Hoop Bracing (MHB)?
Main hoop braces can be attached lower than 160mm below the top-most surface of the main hoop
Main hoop braces can be made of any materia
Main hoop braces must be attached to the side impact structure
Main hoop braces must be straight
Which of the following statements about the primary structure is true?
Chassis members, guides and supports that transfer load from the drivers restraint systeminto the side impact structureare part of the primary structure
The main hoop, front hoop and the side impact structure together is called the primary structure
The Roll hoop braces & supports are not part of the primary structur
In the case the Front bulkhead & front bulkhead support system do not transfer load from the drivers restraint, both the front bulkhead & front bulkhead support system are no part of the primary structure
Which one meets the positive locking requirement?
Washers
Loctite
Cotter pins
Bolts with nylon patches
The approved fire resistant material PBI is
Plastic Ballistic insulator
Polybutane Incompressive
Polybenzide itac
Polybenzimidazole
The maximum restrictor diameters which must be respected at all times during the competition are:
10mm
20mm
25mm
30mm
Exceeding page / slide limit for a presentation or submission will lead to penalty of
5
7
10
15
For wet tires there is a minimum tread depth of
2mm
2.2mm
2.4mm
2.5mm
Minimum cross section area of Main and Front hoops, shoulder harness mounting bar is
91 mm^2
175 mm^2
119 mm^2
150 mm^2
BOTS may consist of
Parallel connection of switches
Series connection of switches
Both A and B
None of the above
Any aerodynamic device must be able to withstand a force of ___ applied in any direction at any point and not deflect more than __.
50N , 25mm
50N , 10 mm
200N , 25mm
200 N , 10 mm
In order to have a protest considered, a team must post a __ point protest bond which will be forfeited if their protest is rejected
10
15
20
25
The ground clearance may be tested at _____.
Mechanical Inspection
Technical Inspection
At any time
At endurance event
The head restraint, its attachment and its mounting must withstand a force of ____ applied in the rearward direction at any point on its surface.
800 N
850 N
890 N
900 N
{"name":"FAR QUIZ", "url":"https://www.quiz-maker.com/QPREVIEW","txt":"Welcome to the FAR Circuit Compliance Quiz, designed to test your knowledge and understanding of the technical specifications and requirements essential for circuit compliance in motorsport scenarios. Are you ready to challenge yourself? Key Features: Multiple choice questions covering various technical aspectsEngaging format to enhance learningImmediate feedback on your answers","img":"https:/images/course8.png"}