RuleBook T1-T10

Which of the following is/are NOT rule compliant ?

The combustion vehicle uses oil as coolant.

K-nuts are used for locking bolts in Suspension System.

Fasteners used for scatter-shield mounting are 5mm in diameter

Brake pedal is fabricated from Titanium.

What is the maximum length (in forward direction) of the front wing extending outboard than the front wheels? (Answer in mm)

What is the density of a head restraint which has dimensions 160x180 with a mass of 155g? (assume min. dimensions if not provided & answer until two decimal points in g/mm3)

How can you attach IA assembly if bolted?

10 mm bolts

8 mm metric 8.8 bolts

10 mm class 10.9 steel bolts

2 fasteners of 9 mm metric 8.8

What is the strain at a non-welded joint for the calculation in SES if a force of 50kN acts on an area of 1.2in? (answer up to 2 non zero decimals)

Team AGNI got selected to participate in FSAustria. The dates of the competition were announced and acceleration event will be on December 31st 2020 and endurance on January 1 st 2021. They have outsourced a harness with a SFI spec 16.1 dated 12/31/2018 from another team. Will the team be able to participate in all the events even if they clear the TI?

Yes

Can't Say

If a bent tube is used anywhere in the primary structure ,other than the front and main roll hoops an additional tube must be attached to support it, the attachment point must be the position

Along the tube where it deviates farthest from a straight line connecting any one end

Where the ansys analysis holds true at any point

Along the tube where it deviates farthest from a straight line connecting at the peak

Along the tube where it deviates farthest from a straight line connecting both ends

For not welded driver's harness to steel structure, attachment points of anti submarine belts should support load of ___. (Answer in kN)

For chromoly tube of 25.4mm outer diameter, what should be the min radius of bend measured at tube centerline for a bend in main hoop 330mm from top most point of main hoop to make it compliant ?

24.8 mm

48.4 mm

62.8 mm

None of the above

in case of SIS being a part of composite structure, the vertical SIS must have an absorbed energy equivalent to __