Rulebook 2
FB2023 Competition Quiz
Test your knowledge about the FB2023 competition rules and requirements with this informative quiz. Whether you're a seasoned participant or a newcomer, this quiz aims to enhance your understanding of the rules that govern vehicle participation.
Topics covered include:
- Vehicle eligibility
- Technical specifications
- Safety requirements
- Documentation and registration
For the FB2023 competition, first year vehicles that participated at FB2022 will not be considered as a second year vehicle.
False
True
CR -
Cost Report
Cost & Manufacturing event
Correction request
Consideration request
Participants who have completed on-site registration (i.e. Registered and present on-site) and have submitted all relevant documents shall receive an electronic participation certificate within __________ of the competition completion.
1 week
3 week
4 week
2 week
Waste oil must be taken to the fuel station for disposal
True
False
No part of the vehicle may enter a keep-out-zone defined by two lines extending vertically from positions _______ in front of and ______ behind the outer diameter of the front and rear tires in the side view of the vehicle
75mm, 75mm
80mm, 75mm
65mm, 75mm
100mm, 100mm
Enclosed chassis structures and structures between the chassis and the ground must have two venting holes of at least ______ diameter in the lowest part of the structure to prevent accumulation of liquids. Additional holes are required when multiple local lowest parts exist in the structure.
25mm
50mm
75mm
40mm
Non-welded strength for continuous material calculations, Young‟s Modulus (E) =
180 MPa
200 MPa
200 GPa
210 GPa
If composite materials are used in the primary structure or the TSAC, the SES must include:
Material type(s)
Resin type
Number of layers
All of the above
On all vehicles, a ______ solid steel or _______ solid aluminum AIP must be integrated into the IA.
1.5mm, 4mm
1.8mm, 4mm
1.5mm, 5mm
2mm, 4mm
The closeout must extend from the rear bulkhead to the firewall.
True
False
Finger guards are required to cover any drivetrain parts that spin while the vehicle is stationary with the engine running. Finger guards may be made of lighter material, sufficient to resist finger forces. Mesh or perforated material may be used but must prevent the passage of a 12 mm radius object through the guard.
False
True
The center of any master switch must not be mounted lower than the vertical distance of the template‟s (see T4.3) middle circle center to the ground surface multiplied by ____
0.70
0.10
0.90
0.80
The name must be displayed and written in Roman Sans-Serif characters of at least _______ high on both sides of the vehicle.
50mm
60mm
75mm
65mm
When power is removed, the electronic throttle must immediately close at least to idle position ±5%. An interval of one second is allowed for the throttle to close to idle, failure to achieve this within the required interval must result in immediate disabling of power to
Throttle
Ignition
Fuel valves
All of these
The number of tools that may be used in this area is restricted to those which can be safely carried by the four team members in one trip.
False
True
{"name":"Rulebook 2", "url":"https://www.quiz-maker.com/QPREVIEW","txt":"Test your knowledge about the FB2023 competition rules and requirements with this informative quiz. Whether you're a seasoned participant or a newcomer, this quiz aims to enhance your understanding of the rules that govern vehicle participation.Topics covered include:Vehicle eligibilityTechnical specificationsSafety requirementsDocumentation and registration","img":"https:/images/course1.png"}